SEAJET 132 POLYURETHANE TOPCOAT

SEAJET 132 Polyurethane Topcoat – two-component polyurethane topcoat Exceptionally high gloss and long-lasting colour retention – a professional finish for hull and deck above the waterline SEAJET 132 is a high-quality two-component polyurethane topcoat for interior and exterior boat surfaces above the waterline. It produces an exceptionally high, mirror-like gloss and a very hard, resistant film that retains its shine and colour for years despite strong sun, salt and weathering. Compared with one-component paints, it offers considerably greater hardness, resistance to abrasion, chemicals and UV rays, and a longer coating life. It is the right choice for owners who want a professional, long-lasting finish. Benefits Exceptionally high gloss – mirror-like appearance Long-lasting gloss and colour retention – excellent UV resistance Hard, tough film – resistant to abrasion, scratches, salt and chemicals Long coating life For interior and exterior use High coverage – approx. 12–16 m²/l Areas of use Hull above the waterline, superstructures, cabins, decks (with an added non-slip additive), hatches, metal and wooden fittings, boat interiors. Above the waterline only. Technical data Colours: pure white, cream, oyster white, mid blue, dark blue (navy), black, signal red, British racing green Packaging: 1 l (base + hardener) Mixing ratio: 75 : 25 (by volume) – base : hardener Pot life: approx. 50 minutes at 20 °C Coverage: approx. 12–16 m²/l per coat (theoretical) Film thickness: 61–82 µm wet / 30–40 µm dry per coat Application: brush, roller, spray Thinner: SEAJET Thinner P Application temperature: at least 12 °C, humidity up to 80 % Drying times (at 20 °C) Touch dry: 2 hours Fully dry: 8 hours Recoat: minimum 24 hours Recommended coating system GRP: SEAJET 117 Multipurpose Epoxy Primer (white) + at least 2 coats of SEAJET 132 Wood, steel, aluminium: appropriate surface preparation and primer (SEAJET 117; on aluminium first SEAJET 017) + at least 2 coats of SEAJET 132 Using the white version of SEAJET 117 as the base ensures an even colour in the topcoat. Instructions for use 1. Clean, degrease and sand the surface (P180–P280). Remove the dust. 2. Stir the base well, add the hardener in a 75 : 25 ratio and mix thoroughly again. Thin with SEAJET Thinner P if necessary. 3. Mix only as much paint as you will use within approx. 50 minutes. 4. Apply in thin, even coats. For the best gloss, use a foam roller and immediately tip off each coat with a brush (“roll & tip”). 5. Lightly sand between coats with P320–P400 sandpaper and remove the dust. 6. Apply at least 2 coats. Tip Do not paint in direct sunlight, at temperatures below 12 °C, in damp weather or onto a damp surface. Paint in still air and in a well-ventilated area. Safety labelling (GHS/CLP) – base Pictograms: GHS02, GHS07 Signal word: WARNING H226 Flammable liquid and vapour. H315 Causes skin irritation. H317 May cause an allergic skin reaction. H332 Harmful if inhaled. H335 May cause respiratory irritation. The hardener contains isocyanates – observe the labelling on the hardener label.