SEAJET 030 WARRIOR

SEAJET 030 WARRIOR – self-polishing antifouling Effective, affordable one-season protection for the underwater hull SEAJET 030 WARRIOR is a self-polishing antifouling based on synthetic resin and cuprous oxide, intended for all types of leisure craft – sailing yachts and motorboats alike. It is designed for areas with low to medium fouling, such as lakes, rivers and most coastal waters. The surface layer renews itself evenly while under way, so the hull stays smooth and old layers do not build up. Its excellent price-to-performance ratio makes it one of the most popular choices for owners who want reliable protection for one season. Advantages Attractive price with reliable performance Self-polishing action – a smooth surface and less sanding at the next refit Fast drying – launch just 6 hours after the last coat (at 20 °C) For salt, brackish and fresh water Suitable for drying moorings, where the boat settles on the bottom at low tide For boats up to 40 knots Compatible with most existing antifoulings Application area Underwater hulls made of GRP (fibreglass), polyester, wood and steel. ⚠️ Not suitable for aluminium, as it contains copper. For aluminium hulls, choose SEAJET 027 SAIKŌ. Technical data Colours: red, blue, black Pack sizes: 0.75 l / 2.5 l Coverage: approx. 9.4–10 m²/l per coat (theoretical) Dry film thickness: approx. 47–50 µm per coat Application: brush, roller; spraying for professional use only Thinner: SEAJET Thinner A (0–5 %) Application temperature: air 5–35 °C, substrate 7–35 °C, humidity up to 85 % Maximum time before launching: 6 months after application Shelf life: at least 2 years at 20 °C Drying times (at 20 °C) Touch dry: 30 minutes Fully dry: 4.5 hours Launching: after at least 6 hours (10 hours at 10 °C, 16 hours at 5 °C) Recommended coating system New GRP and steel: SEAJET 117 Multipurpose Epoxy Primer + 2 coats of SEAJET 030 WARRIOR Wood: SEAJET 015 Underwater Primer + 2 coats of SEAJET 030 WARRIOR Over existing antifouling: if the existing coating is unknown or incompatible, first apply SEAJET 015 as a barrier coat Directions for use 1. The surface must be clean, dry and free of grease, salt and fouling. Lightly sand the old coating and remove the dust. 2. Stir the paint thoroughly before use. 3. Apply 2 coats. Apply an extra coat to exposed areas – the leading edge of the keel, the waterline, the rudder and the drive units. 4. Observe the minimum drying time before launching. Tip For areas with heavy fouling or for longer-lasting protection, choose a higher-performance SEAJET antifouling. Drying times are longer at low temperatures and high humidity.